Can we also get CAN/OBD data using Dashcam?

• Related Articles

• Can the vehicle be immobilised using Dashcam and a relay?

  Currently, Dashcam has some limitations in supporting immobilisation using a relay. So, it's not recommended.

• Currently the dashcam stops giving data once the vehicle is turned off and this results in the vehicle going offline. Can this be solved?

  Yes. We are working on a feature called Stealth mode which will address the issue of device going offline. This is how it will work; 1. Dashcam will be put into standby mode once the vehicle is turned off. This helps in reducing the power consumption ...

• What are the logics of event detection on the new platform? Are we using the same logics which we were using on the old platform?

  There have been certain changes in the logics we are using on the new platform to detect events, specially on the DMS side. For details, here is the documentation.

• What is the current process of device dispatch and installation?

  Following steps need to followed for any pilot/existing account where new platform is being offered; 1. Procurement of devices - This step as same as the case of old VT. Procurement team has to be notified as per the process to ensure timely ...

• The current device onboarding process is too cumbersome and time consuming. Can we not get devices pre-fitted with the new VT firmware directly from Mitac?

  We are working with Mitac on this and it may take till end of October. Till then, we will have to continue with the current process of updating the new VT firmware by connecting the devices with a computer/laptop on the site.